Bara Jabali

  • Total activity 104
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 4
  • Subscriptions 58

Activity overview

Latest activity by Bara Jabali
  • Bara Jabali created an article,

    My wheels are off center, wobbling or vibrating

      The Problem Mid to late last year, we made a major improvement with the formula of our R-SPEC Ghost wheels and outwheels. By all reports thus far, they have far superior durabili...

  • Bara Jabali created an article,

    My battery wont charge all the way to 100%

    Does your board refuse to charge all of the way to 100%? Normally, the battery should charge fully to 100% and stay at that level when the charger is unplugged. At times, the board can stop accepti...

  • Bara Jabali created an article,

    My motors do not fit the 3.5mm connectors that came with the FOCBOX

    Motors can have a variety of connector sizes Some customers may want to use their FOCBOX motor controller with a motor that does not fit the standard connectors. This is quite a common procedur...

  • Bara Jabali created an article,

    How to adjust braking and acceleration on your Unity

    First, be sure that your Unity is up to date by following this guide Connect your Unity You should power the board on, open the app and click on "Scan" and "Connect Bluetooth"(m...

  • Bara Jabali created an article,

    How to adjust braking and acceleration on your Unity

    First, be sure that your Unity is up to date by following this guide Connect your Unity You should power the board on, open the app and click on "Scan" and "Connect Bluetooth"(m...

  • Bara Jabali created an article,

    How to Update the Unity for a Raptor 2.1 or DIY Board VIA Android OR Windows PC

    Latest Firmware Version: 22.44                             Updated On: 27/5/2018 This guide will show you how to update the firmware on your Focbox Unity using your Android phone or Windows compute...

  • Bara Jabali created an article,

    How to unplug the battery

    Tools needed: 3mm Hex tool  Flat Head Screw Driver   Remove the 8 screws on the the enclosure using the 3mm hex tool  Unplug the two connectors shown below   If you need to remove the battery, yo...

  • Bara Jabali created an article,

    How to remove the Battery Box Lid Enclosure

    Tools needed: 3mm Hex tool  Phillips screw driver Flat head screw driver   Remove the 8 screws on the the enclosure using the 3mm hex tool    Follow this guide to secure the lid back on after open...

  • Bara Jabali created an article,

    How to adjust the percent display

      If your display always reads 100% then your display may not be calibrated correctly.  That can be solved by holding the button on the back of the display before the board turns on then clicking i...

  • Bara Jabali created an article,

    How to install a new Etray

    This guide will show you how to replace the Etray on your Raptor 2.1 Tools needed: 3mm Hex tool  Phillips screw driver Flat head screw driver   Step 1) Remove the 8 screws on the the enclosure usin...