3mm hex tool
4mm hex tool
Small flat head screw driver
Step 1) Remove the 8 enclosure screws with a 3mm hex tool
Step 2) Unplug the sensor and motor wires in question
Step 3) Jam the small flat head screw driver in the motor clip and lever it to one side to pop the clip out.
Step 4) Unscrew the truck bolts using a hex tool and skate tool
Step 5) Unscrew the 8 bolts on the hanger with a 4mm hex tool
Step 6) Pull the motor straight out without bending the heat pipe
Step 7) Push the new motor onto the heat pipe in the same direction as the old motor.
Step 8) Bolt the 8 screws down with a high force, use thread lock fluid if available.
Step 9) Reinstall the rear assembly, glue the motor connections with hot glue
Step 10) Close the enclosure following this guide
Step 11) Re calibrate the motors by following this guide