This guide will show you the correct way to swap out the deck of the Raptor 2.
The first step is to unscrew the rear four screws that hold the rear truck on. To do this you will need the included skate tool and a 3mm hex wrench.
Once the four first screws/nuts are removed you can move on to the next step. Unscrew all of the 6 screws on the top of the deck, these screws require a 3mm hex tool. Once doing this your entire enclosure and rear assembly will come loose.
Make sure to not unplug any of the 6 phase wires or swap the 2 sensor cables, if you do unplug any and don't plug them back to the same exact position then you will need to re calibrate the Focboxes.
The end result should look exactly like this
To reassemble, just use reattach the enclosure using the 6 screws and bolt the rear assembly back on to the deck and you are good to go!